Michael Fremer

Why bother with three phono preamps most of us can't afford? For the same reason the enthusiast automobile magazines cover the newest Ferraris and Lamborghinis: just reading about them is fun.

As long as you're spinning an LP for your listening pleasure, and if digitizing it at a resolution of 24-bit/192kHz is transparent to the analog source, why not record and store the LP on your computer at that high sampling rate for future convenient playback via iTunes or for iPod use, or for burning to CD-R? And, while you're at it, why not record the LP unequalized and apply the RIAA curve in the digital domain, where you're not dependent on capacitors and resistors that are imprecise to begin with, and can drift over time? With no drift of phase or value, the virtual filter's results should be better than with any analog filter. And in the digital domain, you can program in any curve known, and select it at the click of a mouse. Aside from the sweat equity invested in programming it in the first place, it wouldn't add a penny to the program's cost.

The minuscule electrical output of an analog signal from a moving-coil cartridge needs to be boosted before it can be converted to digital and equalized in the digital domain. Of course, you could use your current phono preamplifier and record an equalized signal to hard disk, but then you wouldn't get to experience Pure Vinyl's digital RIAA correction—nor would you be able to avail yourself of all the equalization curves provide by Pure Vinyl, of which there are almost too many to count.

This tiny, lightweight, battery-powered jewel is loosely based on Nagra's VPS phono stage that I reviewed in October 2008 but uses bipolar transistors instead of tubes. The bottom of the company's familiar brushed-aluminum case has a grippy rubber material die-cut to spell Nagra. It's intended to keep the preamp from sliding, but stiff cables will have the BPS hanging in the air if you're not careful. The BPS costs $2399.